← All projects

TRIP and TWIP as Key Tools to Design Advanced AM Alloys for Aviation Structures (T3Design)

Completed project, 10/2023–03/2025

Additive manufacturing reduces the large amount of machining waste produced when aircraft structures are made by conventional methods. For large components, wire-arc additive manufacturing (WAM) is particularly attractive because of its high deposition rates and material efficiency. WAM structures, however, contain process-related imperfections such as pores or coarse columnar grains, and complex geometries or integrated functions (e.g. embedded optical fibres for condition monitoring) add further stress concentrators. Materials with high strain hardening are needed to reduce these local stress peaks. The standard alloy Ti-6Al-4V shows only weak strain hardening, whereas Ti alloys exploiting transformation-induced plasticity (TRIP) or twinning-induced plasticity (TWIP) have a large hardening potential, but low strength and have not been optimised for WAM.

The aim of T3Design was a new alloy concept that uses the TRIP and TWIP effects in Ti alloys processed by WAM, with mechanical properties at least equivalent to Ti-6Al-4V and a high defect tolerance. Alloy variants were screened with a combined numerical and experimental approach: thermodynamic database calculations, the semi-empirical Bo–Md concept for the dominant deformation mechanism, and notch compression/tension tests.

Our group contributed ab initio calculations of the deformation mechanisms in metastable β-Ti alloys, to understand at the atomic level how the alloy composition decides whether TRIP, TWIP or dislocation slip is active. Alloy production, WAM processing and characterisation were carried out at LKR Ranshofen.

Team

Johann Grillitsch, David Holec

Partners

Funding

Austrian Research Promotion Agency (FFG), programme TAKE OFF (call 2022).

Selected publications

  1. D. Holec, J. Grillitsch, J.L. Neves, D. Obersteiner, T. Klein: "Ab initio modeling of TWIP and TRIP effects in β-Ti alloys". J. Mater. Res., (2025). DOI: 10.1557/s43578-025-01657-w
  2. T. Klein, J.L. Neves, D. Obersteiner, J. Grillitsch, D. Holec: "Microstructure and deformation behavior of the wire-arc directed energy deposited high-performance near-β Ti-10V-2Fe-3Al alloy". Mater. Sci. Eng. A Struct. Mater., 943(148825), 148825 (2025). DOI: 10.1016/j.msea.2025.148825
  3. J.L. Neves, T. Wojcik, D. Obersteiner, J. Grillitsch, D. Holec, D. Kiener, T. Klein: "Wire-Arc directed energy deposition of metastable-β alloy Ti-15 V-3Cr-3Sn-3Al using thick wire feedstock: Microstructure and mechanical response". Mater. Des., 259(114757), 114757 (2025). DOI: 10.1016/j.matdes.2025.114757